Main > Main Forum
Help. Can't get 60 in 1 to work with my CGA monitor.
deadxstop:
This is my first post, so please be gentle with me.
I'm converting a Phoenix jamma cab into a 60 in 1 but when I installed the board the screen is all lines. The sound works perfect and if I can hear the sounds while moving the stick around. I see colors flashing but it's like the vertical hold needs to get tweaked. I double checked and the CGA monitor works perfectly with the old Phoenix jamma board.
I know this has to be something simple but there is no one out there that I know to ask.
Please Obi-wan, you're my only hope.
TOK:
It appears to be running out of sync. There should be a dip switch to run at CGA or VGA.
Is it in CGA mode?
TOK:
In the 4 bank dip switch, switch 2 should be off for CGA if this is the board you have.
http://www.jammaboards.com/arcade_manuals/60-in-1_iCade_Classic_Arcade_Manual_Online.pdf
deadxstop:
Yes, all the dip switches are off, meaning switch two is set to CGA
paigeoliver:
That could also just be adjustments. I have never had an X in 1 board that didn't require extensive monitor adjustments before it displayed correctly on a CGA monitor. I actually had to put a width cap in one 19 in 1 machine because the thing outputted so wicked narrow that I couldn't get the image adjusted any closer than an inch from the sides.
Navigation
[0] Message Index
[#] Next page
Go to full version