Main > Main Forum

Best way to fill metal cp holes?

<< < (2/3) > >>

elkameleon:
I have the same machine, I just had a new cp made... but I have the resources for that, so do what everyone else said.

mgb:
I actually took the metal knock outs out of 4" electrical boxes and jb welded them in and then bondo'd. they help op great, even when drilling my new holes actually overlapped the filled holes

Le Chuck:

--- Quote from: elkameleon on February 14, 2012, 04:19:15 pm ---I have the same machine, I just had a new cp made... but I have the resources for that, so do what everyone else said.

--- End quote ---

So when are you going to start sharing the wealth?  :bat  I've got metal that needs bending.  Plans... big plans. 

Q*Bert_OP:
Why not just leave the holes there and cover the overlay with plexi?

elkameleon:

--- Quote from: Le Chuck on February 15, 2012, 12:02:58 am ---
--- Quote from: elkameleon on February 14, 2012, 04:19:15 pm ---I have the same machine, I just had a new cp made... but I have the resources for that, so do what everyone else said.

--- End quote ---

So when are you going to start sharing the wealth?  :bat  I've got metal that needs bending.  Plans... big plans. 

--- End quote ---
Hey, I would, if I knew the guys in the shop were competent enough to follow my design the first time! I don't have any problems at the plasma table, because well, I design what gets cut out, but they always ALWAYS screw up the bending! I had my CP made 3 times before it was right...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version