Main > Main Forum
Best way to fill metal cp holes?
mrcram:
I would like to fill these before I put on a new overlay as cp will now be used for gun holster. Best method? Its on a virtua fighter 2. That thin sheet metal stuff.
Sent from my LS670 using Tapatalk
Hoopz:
Bondo and sand. :cheers:
Le Chuck:
JB Weld some sheet metal onto the bottom to brace the holes then bondo and fill the top.
Dervacumen:
What they said. I'm finishing one up now. On mine the epoxy I used to attach the backing plate failed on one hole so the bondo kinda squeezed out a little bit, but no harm.
migraineman:
Add some kind of backing material and bondo the front. My Gals Panic II cab was heavily modded by a previous owner - brazed a galvanized steel outlet box cover to the back. Ugly on the back, but smooth on the front. JB Weld should work fine in this application, as there's no real load on the panel.
Navigation
[0] Message Index
[#] Next page
Go to full version