Software Support > GroovyMAME

Monitor presets

<< < (15/22) > >>

ArcadeBliss:
The WG d9400 and d9800 support 1024x768 interlaced. What modeline do I need to enter in VMMaker to be able to have this resolution?

I found this in the Soft15Hz section but I am unable to covert it over to VMMaker: modeline '1024x768@59,959i' 29,49 1024 1040 1136 1200 768 776 782 820 interlace -hsync -vsync

Calamity:
Hi ArcadeBliss,

You don't have to enter any modeline, but a crt_range line (completely different thing). Modify the correct line in the d9400 preset (monitor.ini in VMMaker's folder):

crt_range2  20501-29000, 40-80, 2.910, 3.000, 4.440, 0.451, 0.164, 1.048, 0, 0, 320, 384, 0, 0

by

crt_range2  20501-29000, 40-80, 2.910, 3.000, 4.440, 0.451, 0.164, 1.048, 0, 0, 320, 384, 640, 768

By doing this, you unlock interlaced modes for the 25 kHz (EGA) range. Then you'll need to add the 1024x768 mode to user_modes.ini so VMMaker calculates it.

ArcadeBliss:
THANK YOU!
Worked like a charm.

tonyt76:
Does anyone have a monitor preset for a Sanwa PFX arcade monitor?

Silverwind:

--- Quote from: Calamity on February 19, 2017, 03:16:39 pm ---
--- Quote from: lordoxide on February 19, 2017, 01:07:19 am ---Another +1 for the Betson Imperial 27" (aka Kortek KT-2914)  :applaud:

Not sure if this will help Service Manual

--- End quote ---

Check this: http://forum.arcadecontrols.com/index.php/topic,117489.msg1477621.html#msg1477621

--- End quote ---

Can we add the information to the original post?  I see WG, Hantarex, etc, but no Betson.  Thank you so much!

Navigation

[0] Message Index

[#] Next page

[*] Previous page