Software Support > GroovyMAME
Sync issues with Nanao MS9
Calamity:
--- Quote from: retrorepair on October 13, 2011, 08:05:34 am ---Yeah I will do. I did go through to see if any built in resolution worked but no dice, so we'll see if I can find something it likes :)
--- End quote ---
I believe the key will be to enable composite sync by means of the modeline definition, hopefully that will be possible in next release.
retrorepair:
Well I tried all I can but it's just having none of it so I swapped the chassis out from one of my other cabs and we are back in business. That's the second one that's ok with this setup. Guess the original chassis just has issues, it certainly looks to have had a hard life.. I'll try it later when you update the driver.
I have new problems now though :banghead:
Just about all my 3D games have problems that were not present on the GeForce. For example:
*EDIT* Disabling vsync by force in CCC fixed my issues.
The other big question is, how do I keep 15k functionality for 31k and 15k resolutions while getting 24k resolutions to display properly? Like I said I have a dual sync chassis and like to play daytona, scud race etc in the proper res since I installed a switch to change 15-24k.
Also m2 emu won't even run with your driver installed, I guess since it's set to full screen @ 496x384 and can't find that res. I assume VMMaker discarded it?
iori01:
Hi,
Why not add 24Khz resolution with soft 15Khz ?
In that way you should have :
15khz reso on 15Khz mode
24Khz reso(496x384) on 24Khz mode
31Khz reso on 15Khz mode but in interlaced as MS9 is not tri sync
Calamity:
--- Quote from: retrorepair on October 13, 2011, 07:22:53 pm ---The other big question is, how do I keep 15k functionality for 31k and 15k resolutions while getting 24k resolutions to display properly? Like I said I have a dual sync chassis and like to play daytona, scud race etc in the proper res since I installed a switch to change 15-24k.
Also m2 emu won't even run with your driver installed, I guess since it's set to full screen @ 496x384 and can't find that res. I assume VMMaker discarded it?
--- End quote ---
All that is perfectly possible using the proper options in vmmaker.ini. But first, do you happen to have your monitor's manual available? That would help me figure out the right settings.
retrorepair:
I tried just adding 24khz with soft15khz but it just screwed up the driver, arcade osd showed just 3 resolutions.
I'll try and find the info but I think there's not much in the way of a manual for the ms9, just pages with adjustment info.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version