Main > Main Forum

Ultralux button construction?

<< < (2/3) > >>

Knightlore:
Lol, it looks that easy but the Bayonet Fit LED holder has those little notches on the side and they slot into button base only one way.  Once they are in there you can't rotate it.

Edit - if no-one can work out whats going on by tommorow, I'll post up a quick vid to show you I'm not totally mad. :)

BadMouth:

--- Quote from: Knightlore on August 05, 2011, 05:42:45 pm ---Lol, it looks that easy but the Bayonet Fit LED holder has those little notches on the side and they slot into button base only one way.  Once they are in there you can't rotate it.

--- End quote ---

Once they are in, they should rotate about as much as the plunger is being missed.  :lol
If one side has the notch higher than the other and it was put in 180 degrees backwards, then it would go in, but not rotate.

Knightlore:
Well, I've got no idea.  I've tried them both ways and there is absolutely no way I can see of rotating them once they are in without breaking them.

I've also tried giving them to someone else who can't do it either  ???

Ginsu Victim:
You're not trying hard enough. The answer is ALWAYS "twist harder". You aren't the first person to have this problem.

Nephasth:
Get a bigger hammer.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version