More progess!
- mounted my 21" crt, after decasing the thing, I bolted the monitor to a bezel board that will be hidden by the main bezel. That was screwed to 2x2's that are attached to my side panels. Its nice and easy to change out if I ever want to try a different monitor combination.
- I found an old pioneer gm600 18w x 2 around here and wired it to run off the computer power supply driving a couple of pioneer 6" speakers.
- I got brave and cut out my control panel

I'm not using a trackball, instead I mounted a spinner in the middle with two buttons on each side. Of course I went and cut the thing out on the wrong side so I'm going to be filling and sanding before I get my artwork

I recessed the joysticks .25 of an inch, which gave my .5 for under side screws. Its a basic layout but will perfectly functional for what I am planning.
- I'm pretty stoked about where I am now, I will try and get the wiring setup and give the whole thing a test run before I finish the cab! Thanks Knievel and everybody else for the inspiration, the quality of projects on BYOAC is incredible!!!


