Main > Main Forum

Plexi-Glass Monitor Bezel

<< < (3/6) > >>

DNA Dan:
You know another possibility for a clean edge is to use matte board or construction paper glued on the inside of the plexiglass. If you spread a clear glue on very evenly it seems like it would work pretty good.

Donkbaca:
I am using foam core board.  I wouldn't glue it to the glass, I would glue it to a piece of MDF.

DNA Dan:

--- Quote from: Donkbaca on May 12, 2011, 06:57:21 pm ---I am using foam core board.  I wouldn't glue it to the glass, I would glue it to a piece of MDF.

--- End quote ---

Yeah that sounds better. Good suggestion. I don't know how much depth the OP has to work with. I am forced to do the paint method because I only have room for 1/4" glass.

garnerb350:
I used the same paint that i used for my cab (black)...Used painters tape and and when it was dry...peeled tape and flipped over...BAM pexi bezel!

DeLuSioNal29:

--- Quote from: DNA Dan on May 12, 2011, 04:54:20 pm ---Use frog tape and follow the manufacturer's direction. You'll have the cleanest lines possible with little to no seepage. I would also recommend removing the tape BEFORE it completely dries.

--- End quote ---
+1

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version