Main > Main Forum
Plexi-Glass Monitor Bezel
jcutler0902:
Hello,
I am to the point of painting my plexigalss monitor bezel. I am using blue painter's tape to mask off the screen portion. My question is what kind of paint should I use (flat, gloss..etc..)? I realize some of this is personal opionion. I am trying to achieve a nice looking bezel. Any additional tips?
Much thanks
Jason
BobA:
Flat or gloss both look like gloss when painted on the back of the plexi. IMO the flat is easier to apply smoothly.
Cynicaster:
Make sure that when you mask off the plexi, you really press down on the tape at the edges to make sure it provides a good seal. The first time I tried this, the paint crept under the tape in some spots because I didn't press it down smoothly enough.
Eddie_Brock:
--- Quote from: Cynicaster on May 12, 2011, 02:44:52 pm ---Make sure that when you mask off the plexi, you really press down on the tape at the edges to make sure it provides a good seal. The first time I tried this, the paint crept under the tape in some spots because I didn't press it down smoothly enough.
--- End quote ---
I had the same thing happen. Make sure that you peel the masking tape off soon after painting, otherwise as the paint dries, it begins to seep under the tape. I had to use some Q-tips and rubbing alcohol to clean up the edges afterwards. :badmood:
sapro:
Are you spraying, rolling or ?
Navigation
[0] Message Index
[#] Next page
Go to full version