Main > Main Forum
wiring jamma speakers....
lilshawn:
i'll dig up a GT board at the shop tomorrow and check for you.
pharoah007:
--- Quote from: lilshawn on May 04, 2011, 11:53:00 pm ---i'll dig up a GT board at the shop tomorrow and check for you.
--- End quote ---
This may help.....
looks like I have the speakers hooked up in Series.
I have unhooked 1 for now to be sure. I sure would like to use both of them.
Here is a pic from the Golden Tee manual, It showed the speakers in Series.....but it does not show the wires coming from the JAMMA harness...weird.
I labeled the pic...
1 = the speakers
2 = some 3 prong connectors I can not identify.
3 = terminals labled as U43 pin5 and u43 pin 7
http://i4.photobucket.com/albums/y145/p ... kers-1.png
I find it strange that the JAMMA connector is not in this diagram.
My setup....wires form JAMMA connector go straight to the speakers.
lilshawn:
your photo isn't working.
but i had to repair a GT complete machine today and the speakers are indeed just in parallel on the single channel :dunno
so just attach your + of one speaker onto the + of the other speaker. same with the -'s
pharoah007:
--- Quote from: lilshawn on May 05, 2011, 10:34:21 pm ---your photo isn't working.
but i had to repair a GT complete machine today and the speakers are indeed just in parallel on the single channel :dunno
so just attach your + of one speaker onto the + of the other speaker. same with the -'s
--- End quote ---
Right on, thanks man.
That is indeed how I have my speakers wired.
Thanks again for the help.
Navigation
[0] Message Index
[*] Previous page
Go to full version