Main > Main Forum
wiring jamma speakers....
pharoah007:
I am wiring up a GT 2005 I am building and have a question about the speakers...
The jamma harness only has ONE speaker - and ONE speaker +.......I have 2 speakers :(
Can I wire the Neg and Pos speaker wires to the 1st speaker...and them jumper to the 2nd speaker from there??? or is a no no as it will increase the ohms (?)
I have it jumped to the 2ns speaker right now....but I will not throw the switch until I get a response to be sure.
Thanks all.
lilshawn:
speaker terminals L and 10 are standard for 1 speaker, but you should be able to hook up another at position M and 11 (parts side - and solder side +)
the factory golden tee cabinets have 2 speakers with separate wires (not jumped as you say)
pharoah007:
--- Quote from: lilshawn on May 03, 2011, 07:41:33 pm ---speaker terminals L and 10 are standard for 1 speaker, but you should be able to hook up another at position M and 11 (parts side - and solder side +)
the factory golden tee cabinets have 2 speakers with separate wires (not jumped as you say)
--- End quote ---
Humm, the GT manual only shows 1 set of speaker wires in the pinout???
Will it break anything "jumped" to 2 speakers like I have it?
lilshawn:
If the original speaker is 8 ohms, you could replace it with 2 - 4 ohm speakers in series...
Board positive --------(+)speaker1(-)---(+)speaker2(-)----------board negative
That way its still 8 ohms.
EDIT:
--- Quote ---Humm, the GT manual only shows 1 set of speaker wires in the pinout???
--- End quote ---
don't look at the Big Buck World kit manual then.... it full of errors. If you follow the jamma pinout they supplied in the book you'll fry your power supply in the computer and the I/O board. how hard is it to copy and paste?!
pharoah007:
big buck world kit manual?? huh.... I am confused.
Cut and paste?
you lost me man.
Navigation
[0] Message Index
[#] Next page
Go to full version