Software Support > GroovyMAME
GroovyMame for arcade monitors version 0.146u4_013f
bitbytebit:
--- Quote from: androtaz08 on April 18, 2011, 01:25:13 pm ---installed it and made a fresh INI. I know that the custom modeline works because my d9800 hundred syncs UMK3 at 56 hx instead on my arcade vga's normal 52.3. however the sides are pinched in in every game and my d9800 is at the maximum for width. any ideas?
--- End quote ---
Have you set the monitor setting to d9800 in the mame.ini? If not then that is most likely the issue.
androtaz08:
yes I have.
bitbytebit:
--- Quote from: androtaz08 on April 18, 2011, 01:32:40 pm ---yes I have.
--- End quote ---
Try to reset the monitor settings in the OSD to the defaults and see if that helps. I have a d9800 so with mine I don't have to set anything in the OSD at all, by default it all fits correctly. So definitely should technically work, possibly post a log of output with the '-verbose -md 4' as options to groovymame. Also are you using one of the patched/custom drivers for the ATI card? Those have enough modelines to make sure every game can fit correctly. The log output should help me see more though and know if it's the resolution of the modeline being picked or sopmething else.
Calamity:
You also need to create the mode list for your D9800 selecting it in VMMaker.ini and running VMMaker and restarting, because the default modelines installed are for standard arcade monitors only.
androtaz08:
I am not using the custom drivers. Do I need them with the arcade VGA 3000?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version