Main > Main Forum
u360s and restrictor plates
DashRendar:
I agree with the comment about the shafts. Mine are bottom mounted, and I got the long shafts.
IMO, I don't need the long shafts. The standard are just fine.
Also IMO, Ultimarc needs to sell an even stiffer spring than the ones they have. I got the stiff springs, but still feel like my U360s are too loose.
Ginsu Victim:
--- Quote from: DashRendar on August 24, 2010, 04:02:00 pm ---Also IMO, Ultimarc needs to sell an even stiffer spring than the ones they have. I got the stiff springs, but still feel like my U360s are too loose.
--- End quote ---
See, and I think there needs to be an in-between. I think they're a tad stiff at times. :lol
DashRendar:
--- Quote from: Ginsu Victim on August 24, 2010, 04:08:49 pm ---
--- Quote from: DashRendar on August 24, 2010, 04:02:00 pm ---Also IMO, Ultimarc needs to sell an even stiffer spring than the ones they have. I got the stiff springs, but still feel like my U360s are too loose.
--- End quote ---
See, and I think there needs to be an in-between. I think they're a tad stiff at times. :lol
--- End quote ---
Nod, there might be some variety in the springs that are being sold (different suppliers etc?)
ragnar:
--- Quote from: deepblue on August 24, 2010, 03:50:23 pm ---Just this guy's opinion - but dont' get long shafts, especially if you're top mounting. Mine are mostly undermounted and STILL have lots of shaft. Long shafts on a top mount will look like you're operating a tank! :cry:
--- End quote ---
Well, the cabinet is going to Battlezone themed .....
>:D
deepblue:
--- Quote from: DashRendar on August 24, 2010, 04:02:00 pm ---Also IMO, Ultimarc needs to sell an even stiffer spring than the ones they have. I got the stiff springs, but still feel like my U360s are too loose.
--- End quote ---
That's funny, I was going to write that also. I'd like some seriously stiff springs in there myself, as I also find them a little light.
Navigation
[0] Message Index
[*] Previous page
Go to full version