Main > Main Forum
u360s and restrictor plates
ragnar:
My wife got a job offer (YES!) and overtime just got approved where I work (YES!).
So tongiht I am ordering everything. My only question though is in regards to the u360s. What is there movement like without a restrictor plate? Circular, rectangular, etc?
I wasn't going to use a restrictor plate but thinking about it, I might get the 4-way/8-way plate and use the 8 way setting. Or decide later that I want it.
Pros/cons of no restrictor versus restrcitor?
Ginsu Victim:
Circular without anything.
I use the circular restrictor. The throw is a bit too much without it. I also recommend the stiffer springs.
ragnar:
Yes, the stiffer springs are being put on. Just seems to be the way to go from what everyone says.
Since the default is circular, I will be getting the 4/8 way plate to use in 8 way mode.
Much appreciated!
Ginsu Victim:
Well, the default may be circular, but it's a very long throw. I tried the square plates and didn't like them. The nice thing about the U360 is not having to rotate a plate to 4 or 8 way.
ragnar:
--- Quote from: Ginsu Victim on August 24, 2010, 12:45:05 pm ---Well, the default may be circular, but it's a very long throw. I tried the square plates and didn't like them. The nice thing about the U360 is not having to rotate a plate to 4 or 8 way.
--- End quote ---
I suppose that if the 8 way setting bothers me that I could always consider the circular attachemnt. I think the 4/8 way palte and the circular are sold as one item.
Are the 8 way plates to restrictive? Or just to restricive in analog mode?
Navigation
[0] Message Index
[#] Next page
Go to full version