Author Topic: Would there be a problem using 24 Ga wire for button wiring? (Read 1379 times)

Hoagie_one · « **on:** August 07, 2003, 04:24:53 pm »

Dont want to overload something or fry a wire. is 24 Ga Ok for buttons?

REBIRTH · « **Reply #1 on:** August 07, 2003, 05:20:39 pm »

Dont want to overload something or fry a wire. is 24 Ga Ok for buttons?

I used 20 guage myself, but I don't think there is an issue with 24. I'm sure someone can answer from experience though.

night · « **Reply #2 on:** August 07, 2003, 08:30:33 pm »

i wouldnt go smaller than 20.
if the wire is to small its hard to crimp the spades sometimes and it will pull right out

Spaced Invader · « **Reply #3 on:** August 07, 2003, 10:37:01 pm »

Dont want to overload something or fry a wire. is 24 Ga Ok for buttons?

There's very little load on it, so, should work fine. It may be hard to crimp though. If you've got it use it.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news