Main > Main Forum

Control Panel Thickness...Happ controls

<< < (2/2)

justinjstark:

--- Quote from: Jawn on June 02, 2010, 06:38:12 am ---Thanks, I went out and bought 3/4 since they didnt have 5/8. :)

--- End quote ---

3/4 in plus 1/8 plexi gives you 7/8 inch control panel.  If you a using 3/4 in t-molding along the side you will have control panel sticking out unless you sand it down a lot.  I'd recomment 1/2 inch mdf + 1/8 plexi and let the t-molding hang over the bottom a bit; nobody will be able to notice.

Navigation

[0] Message Index

[*] Previous page

Go to full version