Main > Main Forum

Control Panel Thickness...Happ controls

(1/2) > >>

Jawn:
Hello all. I was reading another (very old) thread on CP thickness. From what I've read, 5/8" MDF with 1/8" plexi over it is pretty solid. My question is, will the Happ Super joysticks and Happ Pushbuttons With Horizontal Microswitches fit this thickness?

milkit:
they are made for up to 3/4" i believe, so yes. you can always route out behind the joystick as well. the pushbuttons probably have closer to an inch

Jawn:
Thanks, just one more question :P So will I need to make any modifications to the CP to fit the pushbuttons in or will they just jut out the bottom more?

Desolis:
I've used Happ buttons in a couple of arcade sticks I've made already. Mounted in 3/4" board with 1/8" plexi as well. They fit just fine. You shouldn't need any modification at all.

http://2.bp.blogspot.com/_6EMt9kWBw7A/S7bYAZywo2I/AAAAAAAAAGU/2Vwp2uhHOlM/s1600/IMG_0353.JPG

The buttons on the sides are Happ in 3/4" wood.

Jawn:
Thanks, I went out and bought 3/4 since they didnt have 5/8. :)

Navigation

[0] Message Index

[#] Next page

Go to full version