Build Your Own Arcade Controls Forum
Main => Everything Else => Topic started by: 2600 on June 20, 2008, 08:33:31 pm
-
Looks like I may need to replace my furnace. Anyone have an experience with this or know what I'm in for?
-
For parts and labor, I'd guess around $4000 or so, and that may be on the low end. My parents had it done a few years ago and it cost them close to five thousand.
-
I had my furnace replaced in Feb. '07. They installed a new furnace (Trane), humidifier, new digital thermostat and cleaned all of my ductwork for $1800, including labor. My house is about 1800 square feet.
-
Do you US citizens get any of our European options there?
- 105% effictive hot water furnaces, with low-water-capacity radiators and CO2 regulated air-intake? (Hot air systems are so 80-ties and bad for the air-quality)
- compact warmth/electricity furnaces, that generate both heat and electricity
- 85% effective warmth conversion units between the intake of fresh air and exhaust of waste air
If I see a scheme of a "furnace" in google image search, it feels that you can save more than 50% on your gas bill in the US with simple measures.
Also have a look at things like Kingspan Cooltherm insulation. It has an incredible RC of 4 combined with 2,5 inch thickness.
-
For parts and labor, I'd guess around $4000 or so, and that may be on the low end. My parents had it done a few years ago and it cost them close to five thousand.
What type of furnace is that? Straight furnace or boiler too? My furnace is pretty much end of life and I'm about to start getting quotes for a new one. Straight furnace, hot water is external, forced hot air.
-
That would be for a furnace/boiler combination, and also depends on location in the house. E.G. how much work is involved in removing it and putting the new one in its place.
-
Consider getting a heat pump also. Takes less power to run it v. the furnace. My heat pump runs by itself until temps get under 30 degrees, gets assistance down to 10 or 20 degrees, then the furnace takes over by itself under 10 (estimates on temps but fairly close I think).
-
Consider getting a heat pump also. Takes less power to run it v. the furnace. My heat pump runs by itself until temps get under 30 degrees, gets assistance down to 10 or 20 degrees, then the furnace takes over by itself under 10 (estimates on temps but fairly close I think).
Geothermal? What was the installation cost? Was it retrofit or new construction? What state?