Build Your Own Arcade Controls Forum

Software Support => GroovyMAME => Topic started by: White_widow57 on May 10, 2012, 08:56:37 am

Title: Add resolution for calamity drivers
Post by: White_widow57 on May 10, 2012, 08:56:37 am

Hi, i use calamity drivers with my radeon hd (120 resolutions added) but i don't have the 640x288 for my frontend (maximus arcade). How can i add this resolution with vmmaker? Thanks

Title: Re: Add resolution for calamity drivers
Post by: mazinger-z on May 10, 2012, 11:08:26 am

Yes, you can. Just add it in ResList.txt and launch VMMaker again.

Title: Re: Add resolution for calamity drivers
Post by: White_widow57 on May 10, 2012, 12:32:45 pm

Ok i've juste have to add a line like that:

640 x 288 @ ??

What refresh rate must i use? (50.000000, 60.000000, 30.000000 ...)

Title: Re: Add resolution for calamity drivers
Post by: Calamity on May 10, 2012, 12:51:30 pm

Yes, that's how it works. Just enter 60.000000 for the refresh, the modeline generator will limit the refresh to the maximum for your monitor specs, probably it'll be around 52 Hz or so.

Title: Re: Add resolution for calamity drivers
Post by: steveggz on May 10, 2012, 02:04:27 pm

Do you have to re-run VMMaker after adding a custom resolution to ResList.txt ?

Title: Re: Add resolution for calamity drivers
Post by: Calamity on May 10, 2012, 02:12:23 pm

Quote from: steveggz on May 10, 2012, 02:04:27 pm

Do you have to re-run VMMaker after adding a custom resolution to ResList.txt ?

Yes, that's how it works.

Title: Re: Add resolution for calamity drivers
Post by: White_widow57 on May 10, 2012, 04:14:12 pm

Perfect for Maximus arcade, thanks a lot!