Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: upper2bits on August 17, 2011, 11:27:12 am
-
Brand new, one works great one wont go fully to the right. :censored: Is this normal, is there something wrong with it?
U360 Arcade controller (http://vimeo.com/27818587)
-
Ya seems normal, I have the same problem with one of my ultrastiks. Its the magnet itself hitting the metal bracket. I dont use analog I have all the ultrastiks setup for 8way 4way etc. So a slight movement to UPR registers. Try moving the joystick very slowly and see if it will reach all the way.
-
Ya seems normal, I have the same problem with one of my ultrastiks. Its the magnet itself hitting the metal bracket. I dont use analog I have all the ultrastiks setup for 8way 4way etc. So a slight movement to UPR registers. Try moving the joystick very slowly and see if it will reach all the way.
I have mine set to 8way too and that's what I started looking into it. I was trying to play fighter games and I couldn't go diagonal so I started looking into it and switched my joysticks and the other one works fine.
-
There was a known issue with the little ring that goes around the stick. Some people were getting little shavings coming off that which was causing the symptom you're describing.
I think Andy changed the materials to address that. There's a number of threads on BYOAC about this.
Anyway, that might be what you're running into.
-
None of the four I've owned do that. I'd ask Andy, he's pretty quick to respond to emails.
-
This is an analog mode issue relative to the tracking of the magnet underneath, and where the shaft centers.