Hello,
First Gun4IR build - I am currently hitting an issue after attaching the Camera.
When I go through calibration I'm unable to make it through due to error:
The 4 IR points must be detected in the camera preview:
In the image we can see that there are 3 points detected ... but if I back up further I can see all 4 ... but I still can't do calibration.
I thought at first, this was due to the IR LEDs not being bright enough - but all LEDs were emitting light fine - I then went as far as to bridge one of them in each cluster to make the other two brighter, as I thought maybe the IR LEDs perhaps were not bright enough ... I'm not thinking this is it though (please let me know of your thoughts though).
I've gone through testing here and made a video to share, please take a look - the one strange thing: It's hard to see but: near the end you can see that the tracking of the mouse picked up in the OS, despite jumping around quite a bit, seems to be tracking backwards when moving the gun left to right .... I thought I must have a wire backwards but checked the wiring diagram (pdf and videos) and I seem to have it correct. I've even taken out my 2nd camera (for my second gun) and wired that one up and my issue is identical.
Thoughts on what I'm likely doing wrong?