Recent Posts

3D print is rough, but will be smoothed and surface finished, next, mount this into aluminum sheet:

Looks like a solid start.   

Is this one of your designs or did you find it on a site like Thingiverse?


Scott

You can, sure. Just remember to place a pulldown resistor (i.e. 10K ohm) to each data line (a total of two then).
The 3.3V logic should be not a problem as long as you drive the spinner @3V. Eventually a voltage divider (or other stepdown technique) will do the trick. If you don't want to mess with 3.3V logic, Arduino pro micro or Leonardo is the way

Can you try replacing libswitchres.dll from mednafen-1.31-emu4crt-A20e-win64?

also the same resault

screen shot of device manager in windows 10.

the windows I am running is ( tiny10 x64 beta 2 )

here is the dongle . still in package

son of a gun. This little thing has Bluetooth built in. I did not know this. I bought a dongle for Bluetooth. I did install windows 10 on the 16gb M.2 but after just a few updates it was full. I spent a few days figuring out how to run window 10 from external USB drive. I just got that working. It is updating now. I also went to device manager and saw Bluetooth listed. I paired my ear buds and boom. I have Bluetooth.


Wife was tossing a fit on purchasing a new M.2 drive, Workman's comp has not kicked in yet. I did not mail in paperwork yet, ( well it is in today)
I thought HR did it already. I blew out my knee at work. no Pay for 2 weeks now. were fine. We are preppers and have a HUGE pantry and emergency funds stashed. We will be fine. That's why this project is slow going.

Should be ready to paint tomorrow! Final sanding and hopefully I have enough primer on the MDF edges to not soak up paint and make a mess...

 

Been gone for a while but glad to see some of the legends are still around.
Looking great as always Ond. 

3D print is rough, but will be smoothed and surface finished, next, mount this into aluminum sheet: