Main > Lightguns

Ultimarc AimTrak Light Gun Module -- posted my build @ Hyperspin --

<< < (4/5) > >>

AndyWarne:

--- Quote from: Drakin on October 06, 2009, 11:29:08 am ---The sensor bar needs to be horizontal with the group of 5 leds at center of screen. I don't think the board being an inch higher thatn the monitor will make much of a difference because you'll calibrate the gun anyway.


--- End quote ---
Actually the board itself needs to be centralized horizontally, so the group of 5 LEDs is offset to the left slightly.

Mounting higher than the monitor top should be no problem.

Andy

Ginsu Victim:

--- Quote from: AndyWarne on October 07, 2009, 10:37:02 am ---Actually the board itself needs to be centralized horizontally, so the group of 5 LEDs is offset to the left slightly.
Andy

--- End quote ---

Yeah, I thought that was wrong.

Drakin:

--- Quote from: AndyWarne on October 07, 2009, 10:37:02 am ---
--- Quote from: Drakin on October 06, 2009, 11:29:08 am ---The sensor bar needs to be horizontal with the group of 5 leds at center of screen. I don't think the board being an inch higher thatn the monitor will make much of a difference because you'll calibrate the gun anyway.


--- End quote ---
Actually the board itself needs to be centralized horizontally, so the group of 5 LEDs is offset to the left slightly.

Mounting higher than the monitor top should be no problem.

Andy

--- End quote ---

Thanks Andy,

Hell I guess I got it installed wrong on my cabinet...funny thing though is that it works perfect...go figure??

TAG:

--- Quote from: Drakin on October 05, 2009, 07:17:14 pm ---
--- Quote from: bkenobi on October 05, 2009, 12:27:49 pm ---Hmmm, I've been thinking about just this mod.  I don't like having the sensor board that exposed though.  Can it be put behind clear plexi?  I have quite a few rounds that I saved from my CP (button cut outs).  I bet I could dremel something down to fit in there.

--- End quote ---

I have the sensor board behind my tinted glass...works flawlessly

--- End quote ---

Do you know what level of tint you've got?  I was planning to use Greylite 14 for my monitor glass, which is very dark, and would love to make sure the AimTrak will work behind it.

Drakin:
I used 20% over the whole thing with a boarder thats like 2" of the 20% in strips so the bar is behind the boarder that is the darkest....I don't know what you would call that, 10%? would have to ask a tint installer.

Hoped that helps you.

Navigation

[0] Message Index

[#] Next page

[*] Previous page