Update:
Board arrived today from Quarter Arcade, plugged it in, and after some tweaks, had a working game. Finally! It's one fun game. Thanks once again to everyone. Never could've done this without everyone's help.
Now some fine tuning questions:
Game image doesn't fill the entire screen from top to bottom, leaving about an inch/inch 1/2 gap between the top of the screen and where the image cuts off. Not a big deal, but I'm curious if there's a way to fix this (horiz width coil?)
Got some curl at the right edge of the screen. I'm assuming the curl mod will fix this? However, didn't have this problem with the other game board.
The Player 1 and 2 text, along with the scoreboard text, sits crooked across the screen (had this problem with the other board as well). Doing some research, I discovered that adjusting the yoke rings will fix this. Not sure how to do that, however.
Will get some pics up of the cab in its entirety once I add the finishing touches (new buttons, bezel, etc) and clean it up.
Take care, everyone.