Main > Project Announcements

Nvts’s mountain’s Jukebox (revealed!)

<< < (13/18) > >>

mountain:
Lookin' good  :cheers:

I found a big aluminum knob on ebay that may work for you here.

Martijn:
good find mountain, but just not nice enough to replace the powermate.

The little screw hole really does it  :'(

mountain:

--- Quote from: Martijn on December 18, 2008, 04:21:13 pm ---good find mountain, but just not nice enough to replace the powermate.

The little screw hole really does it  :'(

--- End quote ---

Have a look at these then.  ;)

example 1

example 2

example 3

example 4

example 5

example 6

facesmiths:
are you going to mount that computer on the back of your monitor? I don't know about the elo units but my krystal units get kinda warm so I would keep a little distance between the two. at the very least use some aluminum spacers and a bit of longer bolts. this would ofcourse give room to mount some sort of cooling system to pull air from between them and maybe add to the other fans on the units effectiveness. just my two cents. I'm going to go back to reading the rest of the thread :D

Nvts:
I have a couple nuts for spacers between the two, so the distance would be about 1/2 an inch.  I will also have a fan underneath, pushing air upwards and out the top.  Would this be enough, or should I add some extra space in there?  Is there anything else that I could do to make sure that it stays cool enough?



on an aside, I never thought that ebay has an entire section for knobs.   :P

Navigation

[0] Message Index

[#] Next page

[*] Previous page