| Main > Buy/Sell/Trade - non-retail |
| Offering drilled (hollow) shafts for Joysticks |
| << < (7/9) > >> |
| Luigi:
Took a while to test them but now the LED-sticks are available for Happ Super and Competition Pics in gallery http://www.thludwig.de/arcade/galerie/index.php?gallery=LED-Sticks: |
| kronic24601:
Super old thread ... but ... I'm curious, does anyone know of the "right" 2.5mm Stereo Jack to buy for installing in these? Was thinking of this? But it's kinda large ... http://shop.vetcosurplus.com/catalog/product_info.php?products_id=7002 Is there anything anyone knows of that is smaller? |
| Luigi:
Finally I can offer controllable 5mm-RGB-LEDs (common anode for use with LED-Wiz), prepared to fit into the balltop. Including wires and resistors (120 for green/blue, 100 for red). 5 Euros/each + shaft and balltop (if needed) |
| Franco B:
Good work Luigi :cheers: What did you do in the end? I did some ones for Haruman and I ended up making a shaft with a 5mm bore, M8 thread and opened the thread in the bubble tops out to M8. |
| Luigi:
I tried some things to have the connectors inside the thread but it always ended with damaged isolation of the wires and so there was a short and some LEDs didn't work or even died. So I tested how deep I can drill the balltop and finally had the LED sit on top of the thread :) Of course the LEDs have to be modified so they fit into the balltop. |
| Navigation |
| Message Index |
| Next page |
| Previous page |