Arcade Collecting > Restorations & repair
Donkey Kong back door pictures/drawings needed.
hatrick:
--- Quote from: JeepMonkey on June 20, 2008, 04:17:08 pm ---I think the bottom of the back door sits in a groove in the back side of the cab. I will have to look when i get home in a few hours.
--- End quote ---
I just checked mine and you are right, there is a little groove there that I hadn't noticed before. However, it looks like the groove is smaller than the thickness of the plywood used for the back, so there must be small section of the bottom of the door that is planed/routed thinner than the rest of the door.
I'm guessing here, so correct me if I'm wrong. :dunno
hatrick:
**edit for momentary lapse in intelligence...also known as stupidity :laugh2:
Looks like 3/8" plywood would be the correct thickness?
JeepMonkey:
Here is a pic of my DK back door. You are looking at the outside. The indention is 1/4" deep and 5/16" high.
I do not have the wood working knowledge to tell you how this is achieved, but if a guy had the right tools he might be able to make a little money making back doors.
JeepMonkey:
--- Quote from: hatrick on June 20, 2008, 08:39:00 pm ---Looks like 3/8" plywood would be the correct thickness?
--- End quote ---
My DK back door measures midway between 7/16" and 1/2", so I would assume that it is actually 1/2".
hatrick:
Thanks to JeepMonkey and CheeseSndwch, I think I have what I need. Thanks guys. You were both a big help. :notworthy:
Navigation
[0] Message Index
[*] Previous page
Go to full version