Main > Project Announcements
MAME in baby steps
SithMaster:
If you have the tools you can make it without much trouble. The only part id be worried about is cutting the edges at an angle for the joint towards the front. Measure the dimensions of the top of the panel leaving a little extra towards the front for that angle and so the two parts meet up right. Do the same for the bottom and then work out the angle cuts for both.
Somebody who has more experience will come along shortly and explain it better (maybe with pictures).
skippy0420:
Yea, the support was something that I was not to sure about. The person that did this is 'Justin' on this board from what I can tell. I sent a PM with no reponse as of yet.
i did a search here on 'vesperworks' and that is what I got.
Are my goals on building this CP and of resoring this cab at a later time a little too much for a BYOAC virgin? :dizzy:
Xb0x3r:
In my opinion, I really would have gone with an IPAC or a Thrustvector Afterburner (I feel they deserve a little more credit than they receive, I own one)
Around here we don't talk nicely of the TOKN encoders...just throwing that out there ;D
skippy0420:
I know, I know, I know... :dunno
I purchased the TOKN from the e-bay well over a year ago one night when I first had the thought of taking on a MAME project. I did not do ANY research and hope that for the two players and few buttons that I am going to be using I should not have a problem. I got it cheap so I am going to attempt to use it.
Has anyone actually done the testing on the TOKN32 boards?
skippy0420:
Please refrain from the comments on this. I am putting this pic up so I can get some input on it from Tiger-Heli. Bought it well over a year ago before I knew of this board and other options.....
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version