Main > Project Announcements

MAME in baby steps

<< < (3/6) > >>

skippy0420:
Just wanted to document the encoder's programmed buttons here for anyone that might have a need for the information. It's the TOKN32 pictured above. What are the 'LED's' for???

Input           P2      P1
Joy Up         R      Up Arrow
Joy Down     F      Down Arrow
Joy Left       D      Left Arrow
Joy Rt.        G      Right Arrow
Button 1      A      Lt Ctrl
Button 2      S      Lt Alt
Button 3      Q      Space
Button 4      W      Lt Shift
Button 5      O      Z
Button 6      K      X
Button 7   Enter   C
Button 8   Tab      V
Button 9      T      B
Start           2      1
Coin            6      5
Esc/Pause   Esc   P(pause)
LED            ???      ???

skippy0420:
The wiring.... I am assuming at this time that the 'COM' rows of pins can all be chained together so I have split the grounds to one half and the others to the other side.

EDIT: Scrapping this idea as I have now learned that I will have to run each pair of pins to each switch. That was a good bit of information to know. Thanks Heli!
...and to clarify this encoder is a TOKN KB32L (came with the diodes on the board)
:cheers:

skippy0420:
Just picked up two 3Com 8 port Ethernet hub's for $20 from Craigslist. I hope that they can make a decent little project box for the control wiring. Looking at the Cat6 patch cables for the actual wiring to the switch.

Anyone have issues with Cat6 stranded patch cables?

skippy0420:
Worked on removing the paint with Citristrip this weekend but was not able to save the artwork underneath. It was Centipede but it was messed up before I got to it. Looks like someone attempted to remove it by sanding it off before deciding to painting over it.  :(

Time for the heat gun......


***By the way... Citristrip works very well on Latex paint.....***

TelcoLou:
Let's see some pics!  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page