Main > Project Announcements
Project #2: Pac-man from scratch
amadama:
Ok,
Now I realize that was Nostalgia's cab.
I will try the large piece of ply (I'll use MDF actually since I have lots of it).
Thanks for the tips!
Now I need to figure out how far below the monitor should be from the glass bezel.
Thanks!
Alex
rockin_rick:
I'm not sure about this, but if you are gluing the face of MDF, then I think that it may be recommended to sand/scuff up the face to give the glue more bite. (I think I remember reading that somewhere, sometime)
Rick
JeepMonkey:
Aren't Pac and Ms Pac cabs the same? If so, I can take a few pics of my Ms Pac if it will help. What about Galaga/Galaxian? If so, you might check out Level42's project thread Galaxian No. 815. Lots of pics in there.
Nostalgia:
Actually Ms Pacs and Galaga are the same, regular Pacs are slightly different.
amadama:
Hi guys,
Rick, I will scuff up both sides of the MDF before applying glue (good tip, thanks!)
Jeepmonkey,
Please take the pics of the Ms. Pac if you get a chance. I will end up building one of those too!
Here's one of my goals in this project, fully document the from scratch build of a Pac/Galaxian and then make blueprints for the community.
Thanks guys,
Alex
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version