Cabinet Part Fabrication

[sysrpl]

Hi. You may have previously seen my custom cocktail table parts. They are high quality custom CNC fabricated, made of super strong solid 1/16 gauge cold rolled steel, and come with a flat powder coated finish.

I am writing because parts from my initial order are all gone and am considering placing another order with the fabricator. The question is, are you interested in the continued supply of these parts, or would you prefer other/different parts? Do you have an opinion on the matter?

[whatzcrackn]

I need an ikkari warrior cp.  simalar to the pic?  It can be soild (meaning nothing cut out)  or customized.

Let me know what you can do?  I have the original metal cp if you need size.  I am interested in metal or wood.

Thx

[sysrpl]

I need an ikkari warrior cp.  simalar to the pic?  It can be soild (meaning nothing cut out)  or customized.

Let me know what you can do?  I have the original metal cp if you need size.  I am interested in metal or wood.

Okay, I probably didn't explain myself fully. What I do is draw up plans for parts, and send them off to a CNC fabricator to have them produced en mass. In then end what I offer is a bunch of low cost parts that are precise, strong, and durable.

There is a high cost up front for me, but over time I break even if enough people buy them.

[melidian]

do your glass clips fit mspac/galaga cocktails?  what would or do they cost?

[sysrpl]

do your glass clips fit mspac/galaga cocktails?  what would or do they cost?

Yes, the glass clips are designed to fit those cocktails. I have been selling them on ebay in sets of 8 with a $30 buy it now price. Currently I'm sold out and am asking the people here if they have any interest in another fabrication run, and if they would prefer any design modifications or other/alternate parts.

Mind you it took me three years to sell my last fabrication run, so I hesitate to do it again.