see pic for area I'm talking about
Timoe:
That notch was basically just for my panel design, and to save wood. I didn't need the space that was notched out, so I notched it out. If I cut that part off the control panel, there would be a large gap there...
I would not recommend taking that area away from the CP, however. That part of the cp is the exact width of the cabinet, and rests on the "Lip" part that of the base that is designed to support to control panel. My control panel sticks out a great deal farther than that lip. Unless you use a really good method of securing your CP down, you're going to have trouble because a lot more of your CP will be overhanging the front of the cabinet frame and it'll be unstable.
I hope I expressed that clearly enough, It's 5:00PM, I'm about to leave work, and my brain is totally shot.
--NipsMG