Main > Software Forum
GunCon2 driver here!!! (Bacon is tasty)
swamprat96:
If I ever get them working properly I'll post a tutorial :banghead:
Monitor is back ( thanks to Joey at Jomac in Australia where I am). Now running well after making a video ground jumper for the jamma plug (had none). Tube is OK but not brand new. However the chassis is now working perfectly so it will last a while.
Setup is Mame129, Mala and wingun drivers running yobo generic guncon2 guns on an Arcade nanao 26" monitor. At this stage I am running chrisnacks mame.ini settings with the addition of offscreen reload enabled.
I fired up each game listed below, went in to configuration and set Player1 But 1 by pressing the trigger Until I got Mouse B0. Took several tries but eventually it registered. Did the same for Gun 2 and it came up as Gun2 button 1. Hey it worked so I left it
So I have hooked the PC back up and calibrated gun 1 and 2. I have both guns firing in Lethal Enforcers and tracking fairly well - but no reload working (yes I have set the flag). So went on to Area 51 where reload works and tracking is alright for both guns - but very hit and miss. Then on to Alien 3 the gun. Crap- no tracking at all.
DJ_Izumi:
I'm pretty sure that Alien 3 The Gun isn't even a light gun game, it used gun shaped positional joysticks. o.O
swamprat96:
It wasn't- but my flawed logic says that if the gun is recognised as a mouse- and you can play the game with a mouse then the gun should work. I'm sure chrisnack got terminator2 running with lightguns - and that is a joystick game( well guns as joysticks)
zaktallica:
Did anyone figure out how to map a second button? I overall got these working but mapping a second button aint working..
zaktallica:
no?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version