Main > Monitor/Video Forum

rejuventor help needed i think...

(1/3) > >>

menace:
So i got my B&K 466 rejuvenator the other day and am making up an adapter based on their posted plans for things like this.  I noticed all the other pins have an obvious spot on the cr-23 adapter (which i'm building from an old neckboard socket from a dead k7000) except pin 1--is this the one pin set off from the others, typically encased in the plastic pie piece looking wedge?  Also i notice that on the 466, pin 10 of the default socket is labelled g2 red, g2 grn, g2blu, g3,g4 but the cr-23 socket has pin 1 as g3,g4,g5 and pin 7 as g2 grn --So if you are still following does pin 10 of the 466 socket get hooked to pin 7 or pin 1 on the cr-23 adapter-or both?

Ken Layton:
Go to www.ionpool.net and download the B&K setup book. One of the rear pages has the wiring translation from the old 466 to newer models' wiring.

menace:
Thats what I have been using as my resource so this works out well.  Notice on the 466 round socket pin 10 corresponds to pin 9,10,11,12 on the 467 socet?  Okay, now if you scroll up you see the connections for a cr-23 adapter connections.  Now you see that pin 1 on the cr-23 is g3,g4,g5 and pin 7 is g2 grn right?

I was wondering does pin 10 on the 466 socket get wired to pin 7 or pin 1 on the cr-23 socket--or both?

Also just to confirm that this is in fact pin 1?  I assumed it was but you know what they say about assuming....

Ken Layton:
Are you trying to make an adapter that goes straight to the 466's original round connector or are you wiring the 466 to modern 467/470 rectangular Molex?

If you were wiring direct from the 466 round socket to the tube socket on a cr23 then pin 10 of the 466 would go to both pins 1 and 7 of the cr23. Yes, what you guessed as pin one is correct in you picture (it's the G3 a.k.a. focus voltage).

Here's how you should wire:

466

menace:
Thanks for comfirming ken!  (just as a side note the heater is pin 12 on the 466 and not pin 2 as shown above-likely a typo)  i will be going straight from the 466 to the cr-23 but i figure i would mention the 467 side as it shows the function of each pin--just wanted to make sure I wasn't confusing everyone.  I'll post results back--more for posterity than anything...

Navigation

[0] Message Index

[#] Next page