Main > Monitor/Video Forum

WG K7000

<< < (2/3) > >>

Will:
What program are you using for that test screen you have an color convergance?Is this a menu from the monitor or this a program run in windos.Would love to tweak my monitor a little more.

nitebreed:
the software is advv or advcfg......

nitebreed:
Here Is What Wells Gardner Relpied, Will try and see if it corrects the problem will order parts and let the forum know if that works


thanks for getting that info for me. now from past experience that problem is usually caused by a cap in the horiz phase circuit. majority of the time it was capc28 that is parallel to r69. if that doesn't correct the problem then change c29, c30 or c31. and as a last resort change ic2. so give that a try and keep me informed on your progress.

arcadepcnut:
my monitor had the exact same problem just at the bottom of the screen instead of the top. A slight tweak to the 50/60hz pot fixed it.

nitebreed:
The 50-60hz pot only controls the vertical on the picture .....This is a Horzontal problem....I have ordered the ic2 chip to replace ...having trouble finding c28 which is
5pf 20% 2kv npo ceramic capacitor any one know where i can get a few....????and a good place to purchase components for boards...

by the way if anyone is replacing ic2 bob roberts has them for 6 buck
happs have them for 12 bucks plus 10 buck for orders under 25.00....

Navigation

[0] Message Index

[#] Next page

[*] Previous page