Main > Monitor/Video Forum

WG K7000

(1/3) > >>

nitebreed:
The top inch or so pulls to the left and there seems that there is less signal strength there as well.
I have installed a cap kit, also replaced R70,R71,C30,C31 Here are a few pics

Ken Layton:
Try adjusting the 50/60 hz pot and maybe turn the contrast down a bit. Also check the horiz hold adjustment may be a tad too far one way or the other.

Will:
That looks exactly like how my monitor used to display.Cap kit did not solve problem and I had it completly serviced by a local arcade monitor wizard.He replace fuses redid a bunch of the wiring to neckboard and resolder a ton of bad solder points.The bend is now gone,wish I could be more helpful but the cap kit didnt fix my issues.

dabone:
I noticed you are using advmame.

Have you tried your monitor with a game board or a arcadevga card???


I've had a perfectly good monitor display like that with advmame, and had to change video cards to get a good pic.


Later,
dabone

nitebreed:
yeah I'm using advmame I also get the same thing in windows on that monitor i am using matrox video card and i also have a arcadevga card and from what i remember that one did the same thing ...It's kinda weird because only on that one inch strip when i go to try to square the top with the other 80 percent that is all ready straight it will come over but the bottom of that one inch strip that is bad want line up and vice,vers

Navigation

[0] Message Index

[#] Next page