Need help mounting JLF to conversion plate

[rackoon]

Hello guys. I have built 15 arcades, stand ups, bar tops, and cocktails using this site and all of you folks as resources. Been doing this so long that when I started LCD screens were not an option.

Anyway, I always use plywood control panels, but this time Im using an old metal street fighter control pannel with holes for american sticks. I am using JLF's this time around and bought some conversion plates from Paradisearcade to do so. The sticks I ordered were without plates because I didnt need the stock ones.

Do I need ot take this whole thing apart to put nuts under the black frame. I dont see threads on it. its plastic and would strip out so ill asume thats the case. The m3 screws I orderd seem small. I went to the hardware store and m4 seem goofy to, heads are too small. Someone said glue or locktight is involved also. Could someone give me a point in the right directions plaease. It would be a big help.

[rackoon]

Hmmmmm, OK, took it apart and see hex shapes so its all about a nut being under there. What about glue or locktight though? 

By the way i know some of you experts are laughing hard right now becuase its elementary stuff.

[lilshawn]

it does indeed have locktite on the screws... since you ordered without a plate, it's up to you to supply the machine screw and nut. Going on memory, I believe it is a M4x10 with a countersunk head (also called "flat") will fit just fine. (was going to check the sticks I have to make sure, but it seems i've used them somewhere already.)