Main > Project Announcements

BYO "Nasty-Spinner" UPDATE....

<< < (4/13) > >>

crashwg:
How do you get the quick cap to atatch to the spinner?  Do you fill the cap with something?

Thenasty:

--- Quote from: SirPoonga on April 02, 2004, 01:55:01 am ---someone drinks alot of chocolate milk, huh?

--- End quote ---

Hehe  ;D
Good thing I got kids to help me out. I feel likea Wabbit "Silly Wabbit, tricks are for kids".

Thenasty:
Here is how to BYO Bunny Spinner Top.

Tools Needed

A. Quik Milk Chocolate (Drink it while making one of this)
B. Drawer Knob
C. 3/8 Nut
D. 3/8 Set Screw
E. 3/8 DIE
F. Final Piece what it looks like (Epoxy in the inside)
G. Final Finish product filled w/Bondo (not pictured)
H. Allan-Wrench
Misc not pictured.
Drill w/Drill Bits
3/8 Tap (See pic at bottom).

Thenasty:
First take the Drawer Knob and 3/8 die and make a 3/8 thread.

Then Take the 3/8 Nut and screw it in.

Then Take 3/8 Drill Bit and make a hole in the 3/8 Nut (see pic)

While your at it, make the hole bigger in the center of the  Drawer knob until you get a size of 1/4 (this is for the shaft).

Thenasty:
Then take you 3/8 Tap and make a thread inside the NUT.

Once Thread is made, screw in the 3/8 Set Screw w/Allan wrench.

Navigation

[0] Message Index

[#] Next page

[*] Previous page