Main > Project Announcements

BYO "Nasty-Spinner" UPDATE....

(1/13) > >>

Thenasty:
Here is a write up of how to build one of this.
UPDATE: Now w/Quick Bunny Spinner TOP.
See below for the top of the Spinner Tops.
If you want one PM me and I can make one for you for
$18.00 Shipped in USA.


If you want to build your own "All in One Ultimate Coin Mech" here is the link.
http://forum.arcadecontrols.com/index.php/topic,19200.0.html

Add Diagonal joystick support for Q-bert/Congo Bongo to your Happs 360 Joystcik. Here is the link for the mod.
http://www.arcadecontrols.org/yabbse/index.php?board=10;action=display;threadid=25385

Thenasty:
Here are the tools used:

A. Torx #8
B. Torx #6
C. 6/32 Threader (use to made thread under the spinner).
D. 3/16 wrench
E. Phillip Screwdriver
F. Flathead Screwdriver
G. Long Nose Plier
H. Dremel

Thenasty:
this are the parts needed

A. Mouse (PS2 or Serial) I think USB are all optical.
B. "L" Bracket (dollar store)
C. This nuts are from the Video Card, Sound card, etc..
D. This nut came the Computer Case you bought before.
E. This Shrink Wrap.

Misc Items not listed:
1. Epoxy
2. Blow Dryer (for the shrink wrapper)

Thenasty:
Now you need to get one of this Western Digital Hard Drives. And open it up using the TORX #8 and #6. So you should have this.

Thenasty:
C. This nuts are from the Video Card, Sound card, etc..

Now time to cut this a little shorter to make the a shaft.
Using the Dremel (carefull with this) and cut off about 1/2 of the thread.

Navigation

[0] Message Index

[#] Next page