Software Support > GroovyMAME

Lightgun flasher over groovymame in fullscreen

<< < (11/17) > >>

phasermaniac:
thanks! I'll try this evening.

phasermaniac:
Works but it has a problem: when I shoot a dark zone it shoots and reloads
I think you are reading the coordinates before the flash is applied.
I mean for this its mandatory to read the coordinates after the flash, the closer possible to the button injection

psakhis:
Ohhh, you are right; i'm reading coords before than that.

I think the solution

psakhis:
I write a new version that reads coords after gains.

I hope this is the good one

phasermaniac:
And again, yes it works but...
only with gain until release.
When set gain fixed frames it shoot and reloads (unless i set a huge fixed frames number and I release the button fast).
I bet the reason is the lengh of the button press must be inside the gain time, else when flash is over and you still have the button pressed it sends reload button.
So solution to this might be force end of the button press just before the end of flashing when using gain fixed frames.

Anyways thanks very much for your work, Never had my crt guns working so reliably

Navigation

[0] Message Index

[#] Next page

[*] Previous page