| Main > Project Announcements |
| A 3D Printed, Candy Cab-inspired Wall Mounted cabinet: Ascend |
| << < (2/4) > >> |
| pbj:
That’s cool, I dig it. Akira didn’t have a candy cab in it, though. |
| Zebidee:
I used to work in a club that looked surprisingly similar. |
| emphatic:
Cool basement dwelling. And the candy mockup looks great, look forward to seeing your progress. :cheers: |
| sealcouch:
--- Quote from: Zebidee on July 24, 2022, 02:25:47 pm ---I used to work in a club that looked surprisingly similar. --- End quote --- Yeah. I put the stripper pole away....for now. I decided to tilt it down a bit for control panel ergonomics then lobbed a few inches off the back. Now it's only 16 inches off the wall which is way less intrusive but now I feel like I have to redesign the bottom a bit. |
| Zebidee:
--- Quote from: sealcouch on July 24, 2022, 03:54:53 pm --- --- Quote from: Zebidee on July 24, 2022, 02:25:47 pm ---I used to work in a club that looked surprisingly similar. --- End quote --- Yeah. I put the stripper pole away....for now. --- End quote --- Oh is OK, I'm retired these days anyway. Is a good idea to keep a pole handy though, in case of emergencies! Don't throw out the disco ball! --- Quote ---I decided to tilt it down a bit for control panel ergonomics then lobbed a few inches off the back. Now it's only 16 inches off the wall which is way less intrusive but now I feel like I have to redesign the bottom a bit. --- End quote --- Yeah, just level the bottom against the floor line, right angle from the wall |
| Navigation |
| Message Index |
| Next page |
| Previous page |