Arcade Collecting > Merit/JVL Touchscreen

Megatouch Force Radeon ghost touch problems

<< < (3/3)

Spank:

--- Quote from: Fordman9870 on December 18, 2019, 10:58:02 am ---IS this the norm wire position for running the wire back to the controller box?

--- End quote ---

Looking at the photo, you have the wrong touchscreen installed. It should be a flush mount. That most likely is your problem.

mahkeymike:

--- Quote from: Spank on December 20, 2019, 07:18:28 am ---
--- Quote from: Fordman9870 on December 18, 2019, 10:58:02 am ---IS this the norm wire position for running the wire back to the controller box?

--- End quote ---

Looking at the photo, you have the wrong touchscreen installed. It should be a flush mount. That most likely is your problem.

--- End quote ---

Spank:
The touchscreen is like a 1/2 inch away from the tube in the middle. It has the wrong curvature on the glass. there is no way that is going to fit in the game properly. It is the wrong glass for that tube. It is for a tube with more of a curve.

Fordman9870:
Actually it is the correct screen, That was just my Newbie attempt to get screen away from CRT as i though the CRT was touching the Screen, thereby making the a ghost touch problem occur. When i pulled the screen away 1/4 to 1/2 inch ghost touch was gone. So i put on some mounting tape in between them it worked better but not completely, so i wedged a small piece of foam and that seemed to do trick until i shut the right side panel, then ghost touch was back. so my next step is to reroute the cable like it was suggested and wrap the wire with insulated tape and report back, took a break from it but need to finish it soon as I am also working on a home made retro arcade cabinet. haha too many projects the wife is telling me. Must be my A.D.D :)

Navigation

[0] Message Index

[*] Previous page