Arcade Collecting > Merit/JVL Touchscreen
Megatouch 6000 Access Setup Menu if Coin box button not working
cc17926:
Also, forgot to mention.. Setup, Calibration, and Coin (doesnt matter which) all are shorted to GND for use.
gavinlew:
Thank you
I have posted a picture of the IO board in reply 12 above , from your diagram, the 2 white blocks on the right hand side of the board are not used - I need to re-trace where that wire is going , since its not going to-do much! , I dont recall seeing any volume controls but with your diagram this will help me more.
cc17926:
This is the volume control, as indicated.
Sent from my SM-G955U using Tapatalk
gavinlew:
So with the new IO boards connected I get either of the following screens and the megatouch won’t boot to the game gui
Sent from my iPhone using Tapatalk
gavinlew:
ITS ALIVE!
Found a combination of riser card and IO board that worked , setup/calibration/volume all working fine!
The riser says Megatouch5000 on it but the unit seems happy to boot , did get a hard drive timeout error so need to swap that out to a CF card.
Erotic has been disabled so the machine can now be in the bar
Now am I on the latest Megatouch software that the hardware can run?
Sent from my iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version