Software Support > GroovyMAME
Guncon2 on latest Groovymame?
pubjoe:
Ahhh, I wasn’t aware of that adapter at the time. I just stupidly tried it with a generic PS1 pad adapter.
Foxhole:
Enabled csync on vmm, removed vsync wire, removed resistor, connected everything back, connected the ems usb2 converter, g-con 45 now works. ;D
Foxhole:
No doubt, the namco gun is very accurate, only had to raise the brightness to 1.3 within mame for it to be accurate, with my other guns i had to raise it to about 1.5-1.7 for them to be as accurate.
Calamity:
--- Quote from: Foxhole on February 28, 2019, 07:35:44 am ---Enabled csync on vmm, removed vsync wire, removed resistor, connected everything back, connected the ems usb2 converter, g-con 45 now works. ;D
--- End quote ---
Does the rolling-x issue still exist this way?
Foxhole:
--- Quote from: Calamity on February 28, 2019, 08:32:01 am ---
--- Quote from: Foxhole on February 28, 2019, 07:35:44 am ---Enabled csync on vmm, removed vsync wire, removed resistor, connected everything back, connected the ems usb2 converter, g-con 45 now works. ;D
--- End quote ---
Does the rolling-x issue still exist this way?
--- End quote ---
No. But that is because it's guncon1 and not the ps2 guncon2, i am using a converter for it to work. But nevertheless, it's worth the hassle in my opinion, it's a fantastic light gun.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version