Arcade Collecting > Merit/JVL Touchscreen
HELP! Merit Megatouch Encore 7 - touch not working
mahkeymike:
Well that is a Microtouch controller, so there should be a overlay. I honestly am not sure i worked on this model though. I think the oldest model i worked on was the megatouch 6 and XL's. They had the same stand off type controller but i believe they were labeled "Merit". Normally with Microtouch controllers, that center cable would go to the TS overlay. But i dont see any other connections on the controller. Hopefully someone else that has worked on that model will chime in.
mongoosetoo:
BUMP - anyone have any intel on Megatouch controllers?
Thanks, mongoosetoo
mahkeymike:
Ok i think i figured that model out. See that pic where there is a pin header that says pin 1. The ts overlay goes there with the wire facing to the right.
Here is a pic.
You're looking for a connector/cable comming off the ts overlay that looks like this.
mongoosetoo:
I guess mine may have been removed. I do not see any loose connectors, and when I look at the monitor, it doesn't look like anything can be pulled off - like the overlay is not there. I got this machine from an operator - he may have removed it for another machine. Does anyone have an overlay available? Monitor measures at... 12.5" wide x 9.75" tall. If so, what price with shipping to 43031?
mahkeymike:
Have you tried ebay? I think i still have a old megatouch 6 in storage but i have no idea if the overlay is still on it, or if it works if it is. Plus its a lot of work/time to remove it. But i will check and if its there i think i can test it with a controller from a force or ion mobo and ioboard.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version