Hello:
I have searched the forums unsuccessfully so posting a new thread with my question. I am trying to connect a Happ potentiometer pedal to my MAME cabinet using a U-HID board.
I have soldered three wires to the three tabs on the potentiometer. These have been connected to three pins on the U-HID board
It is my understanding I need to configure the three pins as:
(a) Analogue input
(b) Ground
(c) +5v
Question - does it matter which pin is configured to each of the above (e.g. does the middle tab on the potentiometer have to be ground)
Thank you very much.
Tim