| Arcade Collecting > Restorations & repair |
| . |
| << < (17/18) > >> |
| wp34:
--- Quote from: tebright1 on August 02, 2017, 03:42:13 pm --- --- Quote from: ChanceKJ on August 02, 2017, 12:09:16 pm ---Excellent. We shoot footage for a laminate installation video. but i'm not sure sure how we're going to edit it yet. :( --- End quote --- Have you guys ever used laminate on a CP and drilled through it? I have a restore where I am doing that. I am nervous to ruin the laminate I put on. Sent from my XT1585 using Tapatalk --- End quote --- Did you drill the holes first and then laminate or do you need to drill a hole through both the laminate and the wood? |
| tebright1:
--- Quote from: wp34 on August 02, 2017, 05:23:50 pm --- --- Quote from: tebright1 on August 02, 2017, 03:42:13 pm --- --- Quote from: ChanceKJ on August 02, 2017, 12:09:16 pm ---Excellent. We shoot footage for a laminate installation video. but i'm not sure sure how we're going to edit it yet. :( --- End quote --- Have you guys ever used laminate on a CP and drilled through it? I have a restore where I am doing that. I am nervous to ruin the laminate I put on. Sent from my XT1585 using Tapatalk --- End quote --- Did you drill the holes first and then laminate or do you need to drill a hole through both the laminate and the wood? --- End quote --- Both. Sent from my XT1585 using Tapatalk |
| wp34:
I would recommend clamping a sacrificial board on top that you can drill through. The laminate will be less likely to chip that way. Make sure you drill down into the laminate otherwise it may try to separate from the force of the drill. You could also make a hardboard template with your holes drilled where you want them. Clamp the template on top of your laminate and use a pattern routing bit to route the holes. A router bit would be less likely to chip than a drill bit. --- Quote from: tebright1 on August 02, 2017, 05:48:02 pm --- --- Quote from: wp34 on August 02, 2017, 05:23:50 pm --- --- Quote from: tebright1 on August 02, 2017, 03:42:13 pm --- --- Quote from: ChanceKJ on August 02, 2017, 12:09:16 pm ---Excellent. We shoot footage for a laminate installation video. but i'm not sure sure how we're going to edit it yet. :( --- End quote --- Have you guys ever used laminate on a CP and drilled through it? I have a restore where I am doing that. I am nervous to ruin the laminate I put on. Sent from my XT1585 using Tapatalk --- End quote --- Did you drill the holes first and then laminate or do you need to drill a hole through both the laminate and the wood? --- End quote --- Both. Sent from my XT1585 using Tapatalk --- End quote --- |
| ChanceKJ:
. |
| tebright1:
Thanks guys! This really helps. Sorry to steal some thunder from you thread Chance. Keep up the good work. |
| Navigation |
| Message Index |
| Next page |
| Previous page |