Main > Raspberry Pi & Dev Board

Xin Mo Controller 2 Player Setup on Retropie 3.6 Pi 3B... No clue what to do

<< < (3/4) > >>

Yenome:
I would put in the fix to the cmd file that got them to be seen as two then just reconfigure the controllers again, i had to do that after adding the fix. do note i have a rp2 not a 3 but they both use the same image. also i would format and reinstall retropie just to eliminate any left over misconfigurations.

so what i did was added the line to the cmd.txt like you did. rebooted. then i went into the options menu and redid my player 1 and player 2 controls for retropie. then i booted up a two player snes game and it worked for player 1 and player two. so i think redoing the controls is best. i had never thought nothing of it when the retropie only showed one controller as i was always just using my xin-mo for one player anyway.

Jimd0586:
Ok. I'll reinstall Retropie, change the boot text, and reconfigure. I'm taking a short trip for a few days, but when I get back this weekend I'll give it a shot and let you know how it goes. Thanks for the help!

Jimd0586:
I am curious what your Retroarch.cfg in your all folder says. Does it show both player 1 and player 2 inputs or just one set of inputs after you changed your boot cmt.txt registry?

Like I said, I'll be out of town for a few days but I'll reformat Retropie again when I get back and see what happens.

Jimd0586:
@Yenome

So I got back from NOLA and reinstalled Retropie. I added the line to the cmdline.txt and both controllers showed up. I reconfigured both controllers via the menu in retropie, but still 2nd player is not fully working. Some buttons are just not responding and a few are mipmapped. I am totally lost. I opened Super Mario World as my test and it just isn't working quite right. Not sure what to do now.

Jimd0586:
Just found this out if it helps:

Port0 configs are in the system as: thtthtarcadeconsole2pusbplayer.cfg while port1 is: thtthtarcadeconsole2pusbplayer.cfg.bak

Does that mean anything to anyone? What's so frustrating is that I will config the buttons for each player but upon configuring the second player, first losses its mapping. Only two or three of the six buttons works. So I reconfigure player one and player 2 then loses its mapping. I am really stumped.

Navigation

[0] Message Index

[#] Next page

[*] Previous page