| Main > Everything Else |
| Golden Tee 2001 -2006 CHD's and the U53's, Big Buck Hunter, Carnival King |
| << < (13/17) > >> |
| ed12:
yup the avr is not resopnding right i thought it was me at first so i chked a few chip's no it's fbr let me look into it ed |
| Loopey1:
If I put in a Un program Atmel I do get the proper Device ID. Even one that IS programed but UNLOCKED I get a valid ID. Its only a locked chip that spits out the wrong one. |
| ed12:
dido same thing i chk-ed my new stock on my emp30 then my gq4 then fb and olny locked 1's returned the weird bytes will test in my stk500 tonight but i do think i know why will post u in a byte ed |
| ed12:
ok before my break i have alot done built the 12v to reset circuit..work's like a charm in current low mode 12v is placed on the reset pin in current high mode 3.3 volt's is placed there this is what we want, next i am going to poke a few extra data line's i will explain why later but this next statment may help u > The BA1FB PC based AT90Sxxxx programmer is a easy to build, beginner's development programmer. No power supply needed! Very low cost! What you need is only a DB25 connector to printer port, 20PIN or 40PIN socket and a piece of PCB. It can be also connected to your application system via CLK, MOSI, MISO and GND for In-circute Serial programming ^^^^^^^^^^ ^^^^^^^^ It only support Intel HEX file format. Because SPI program mode does not support RC OSC fuse mode, user should order AT90S1200 for the crystal OSC and AT90S1200A for the internal RC OSC. It's a freeware, so feel free to copy the software to others.< more to follow file attached is 32bit fbprog can be ran under windows 98/xp there is a nt driver for it ed |
| ed12:
i also use this program to do the same thing win32 so run it fron program file's doc's on on ponyprog site ed |
| Navigation |
| Message Index |
| Next page |
| Previous page |