Main > Retail vendors
Laser cut frames, custom joystick balltops, 3D printed designs
shrunkenmaster:
Any chance of repro Tapper handles?
Vigo:
Ooh, that would be cool
Sent from my iPhone using Tapatalk
cudbur:
--- Quote from: Generic Eric on February 10, 2015, 03:25:33 pm ---Could you do a barrel like this?
Instead of the rough edges being exposed, maybe some sort of clear coat so that all of the edges were smooth? Kinda like the fly in amber. The top and bottom could be flat and rough, but the sides have to be smooth.
--- End quote ---
Thanks a ton for all the feedback and questions. I meant to only take a few days but I ended up making a lot of mistakes and learning a lot about casting (each time having to wait 24-72 hours for curing). A lot of feedback was to make it smooth so I took a different approach than before that I thought would address most concerns: embed 3D prints inside a clear resin sphere. I intend to write a blog post about the process but here's how far I've gotten:
I'm by no way complete, so many improvements remain (eliminate flashing, remove bubbles, make barrel less distorted, etc) but I wanted to show you my progress anyway. Thank you sooooooo so much for all your support already. My main hurdle right now is purchasing a vacuum chamber to degas the resin and silicone.
otsep:
Damn fine work. :notworthy:
There are a lot of diy options for the chambers you might want to check out.
yotsuya:
See, THAT's way cooler and ergonomic than a barrel. Looking forward to seeing what you come up with.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version